How do you activate the TPMS sensor with a magnet?
Activating a TPMS (Tire Pressure Monitoring System) sensor with a magnet sensor is a straightforward process, often used for vehicles that support this method. Here’s how you can do it:
- Put the Vehicle in TPMS Relearn Mode:
- Insert the key into the ignition and turn it to the “On” position (do not start the engine).
- Press and release the brake pedal.
- Turn the key to the “Off” position, then back to “On” three times, ending in the “On” position.
- Press and release the brake pedal again.
- Turn the key to “Off” and then back to “On” three more times. The horn should chirp, indicating the vehicle is in TPMS relearn mode.
- Activate the Sensors:
- Start with the front driver-side tire. Place the magnet over the valve stem where the TPMS sensor is located.
- Wait for the horn to chirp, confirming the sensor has been activated.
- Move to the front passenger-side tire and repeat the process.
- Continue with the rear passenger-side tire, then the rear driver-side tire, following the same steps.
- Complete the Process:
- After activating all four sensors, the horn will chirp twice, indicating the relearn process is complete.
- Turn the ignition off to exit relearn mode.
This method works for vehicles that are compatible with magnet-based TPMS activation. If you’re unsure whether your vehicle supports this, consult the owner’s manual or a professional mechanic.
How To Activate Your TPMS Sensor?
Activating your TPMS pressure sensor depends on your vehicle’s make and model. Here’s a general method that’s commonly used:
- Put the Vehicle in TPMS Relearn Mode: Consult your owner’s manual for instructions specific to your vehicle. Typically, this involves turning the ignition key to the “On” position (without starting the engine) and performing a sequence of actions, such as pressing the brake pedal or using buttons on the dashboard.
- Activate the Sensors: Use a TPMS relearn tool (or a magnet, if your vehicle supports this method) to activate each sensor. Start with the front left tire, move to the front right, then the rear right, and finally the rear left tire. Place the tool or magnet over the valve stem and follow the instructions provided with the relearn tool or in your manual.
- Listen for Confirmation: For each tire, you’ll typically hear a chirp or see a light blink when the sensor is successfully activated.
- Complete the Process: After activating all sensors, the vehicle should confirm the process is complete, often with two horn chirps or a message on the dashboard.
How to activate new TPMS sensor without tool Ford?
Train TPMS with no learning tool:
- Make sure your tires are inflated to the recommended psi.
- Turn ignition to the on position.
- Push the hazard light button 6 times.
- Release air pressure in the front left tire until you hear the horn honk.
